Cypress Semiconductor Perform CY7C1380D Especificaciones descargar pdf (Pagina 33)

Chapter 4: Completing the Quartus II Project 4–5

Configure the FPGA

Preliminary

2. Ensure that the power switch (SW1) on the back side of the NEEK is in the OFF

position (up).

3. Connect the USB cable from your PC to the NEEK.

4. Connect the power cable to the NEEK.

5. Press the power switch to turn on the NEEK.

6. In the Quartus II Programmer, click Hardware Setup.

7. Under Currently selected hardware, click USB-Blaster [USB-0].

8. Click Close.

9. Click Auto Detect. The Device column lists the EP3C25F324 device on your board,

indicating that the Programmer detected the device. Figure 4–4 shows the

Quartus II Programmer after you perform this step.

10. If your .sof does not appear in the Programmer, perform the following steps:

a. In the File column, click <none>.

b. Click the Change File button.

c. Browse to your working directory.

d. Select neek_hw_lab.sof.

e. Click Open.

11. Turn on Program/Configure for your .sof.

12. Click Start to program the FPGA.

After the Programmer completes programming the FPGA, the progress bar reaches

100%, and no error messages appear.

Figure 4–4. Quartus II Programmer

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 45 46

Sin comentarios

Cypress Semiconductor Perform CY7C1380D Especificaciones Pagina 33