Cypress Semiconductor Perform CY7C1380D Especificaciones descargar pdf (Pagina 30)

4–2 Chapter 4: Completing the Quartus II Project

Complete the Quartus II Project

Nios II System Architect Design Tutorial © June 2009 Altera Corporation

Preliminary

The Block Design file (.bdf) includes the pins required by the design, a PLL, a

MUX, and some glue logic, but does not include the logic in the SOPC Builder

system. You must add the SOPC Builder system as a new logic block to the

schematic design.

Add the SOPC Builder System to the Quartus II Project

Add the SOPC Builder system to your Quartus II project by performing the following

steps:

1. On the Edit Menu, click Insert Symbol.

2. Open the Project folder and highlight neek_system.

3. Click OK.

4. Place the symbol in the schematic. Align with the correct pins in the schematic, as

shown in Figure 4–2.

1 You may need to move some connector pins to align them with the pins of

the symbol. However, if you have to move and reorder many existing

configuration pins, you should reexamine your SOPC Builder system to

ensure it matches Figure 3–13 on page 3–15.

Figure 4–2 shows the schematic after the SOPC Builder system is inserted.

Figure 4–1. NEEK Embedded Tutorial Project Top-Level Block Diagram

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 45 46

Sin comentarios

Cypress Semiconductor Perform CY7C1380D Especificaciones Pagina 30