Cypress Semiconductor CY7C1381D Manual de usuario descargar pdf (Pagina 14)

CY7C1381D

CY7C1383D

Document #: 38-05544 Rev. *E Page 13 of 29

current instruction. When HIGH, it will enable the output

buffers to drive the output bus. When LOW, this bit will place

the output bus into a High-Z condition.

This bit can be set by entering the SAMPLE/PRELOAD or

EXTEST command, and then shifting the desired bit into that

cell, during the “Shift-DR” state. During “Update-DR,” the value

loaded into that shift-register cell will latch into the preload

directly control the output Q-bus pins. Note that this bit is

preset HIGH to enable the output when the device is

powered-up, and also when the TAP controller is in the

“Test-Logic-Reset” state.

Reserved

These instructions are not implemented but are reserved for

future use. Do not use these instructions.

TAP Timing

TAP AC Switching Characteristics

Over the Operating Range

[9, 10]

Parameter Description Min. Max. Unit

Clock

TCYC

TCK Clock Cycle Time 50 ns

TCK Clock Frequency 20 MHz

TCK Clock HIGH time 20 ns

TCK Clock LOW time 20 ns

Output Times

TDOV

TCK Clock LOW to TDO Valid 10 ns

TDOX

TCK Clock LOW to TDO Invalid 0 ns

Set-up Times

TMSS

TMS Set-up to TCK Clock Rise 5 ns

TDIS

TDI Set-up to TCK Clock Rise 5 ns

Capture Set-up to TCK Rise 5 ns

Hold Times

TMSH

TMS Hold after TCK Clock Rise 5 ns

TDIH

TDI Hold after Clock Rise 5 ns

Capture Hold after Clock Rise 5 ns

Notes:

9. t

and t

refer to the set-up and hold time requirements of latching data from the boundary scan register.

10. Test conditions are specified using the load in TAP AC test Conditions. t

= 1 ns.

Test Clock

(TCK)

123456

est Mode Select

(TMS)

Test Data-Out

(TDO)

CYC

Test Data-In

(TDI)

TMSH

TMSS

TDIH

TDIS

TDOX

TDOV

DON’T CARE UNDEFINED

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Comentarios a estos manuales

Sin comentarios

Cypress Semiconductor CY7C1381D Manual de usuario Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para No Cypress Semiconductor CY7C1381D