Cypress Semiconductor CY7C292A Manual de usuario Pagina 13

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 94
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 12
3. Part is now programmed. If there were any errors during the
process, PGMX will abort with an error message back to the 9000
command mode. Be sure to look at the checksum to see if it is what
it is supposed to be.
4. To repeat the process, insert a new part and type Control–F and
then press the “F3” function key, which will give you the previous
command line that was issued which was FILENAME [tn,u,me.
Pressing <cr> now will cause the process to begin again.
You SHOULD read the rest of the manual to get specific details about
some of the operations performed above, specifically the COM-
MANDS chapter, the DIAGNOSTICS chapter and the PGMX chapter.
Chapter 2 Getting Started Quickly Model 9000
Page 8
Vista de pagina 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 93 94

Comentarios a estos manuales

Sin comentarios